P1703 Engine Trouble Code
Meaning of P1703 engine trouble code is : When the check engine light comes P1703 code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.
P1703 Possible Solution:
Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.
P1703 Code Meaning :
|OBD-II Diagnostic Powertrain (P) Trouble Code For Engine||Fuel And Air Metering||Fuel Rail Pressure Sensor Circuit Malfunction||Cold Start Injector 1 Malfunction||Exhaust Gas Recirculation Sensor B Circuit High|
The oxygen (02) sensors on your car measure the oxygen in the exhaust to determine how rich or lean the ratio of fuel and air are in the cylinders. Optimizing this mixture means better fuel economy and fewer exhaust emissions.
P1703 OBD-II Diagnostic Powertrain (P) Trouble Code DescriptionP1703 OBD-II Trouble Code Indicates that during the Key On Engine Off (KOEO) self-test, the Brake Pedal Position (BPD) signal was high, or during the Key ON Engine Running (KOER) self-test, the BPP signal di not cycle high and P1703 code.
Reason For P1703 CodeThe reason of P1703 OBD-II Engine Trouble Code is Fuel Rail Pressure Sensor Circuit Malfunction.
P1703 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.